SOLID WASTE & HAZARDOUS MATERIALS
Propane Tanks
& Overfill Prevention Device (OPD) Requirements
 All
new cylinders must be manufactured with overfill protection devices (OPDs)
Cylinders
without OPDs are no longer permitted to be refilled by anyone.
The National Fire Protection Association (NFPA) requires
that every refilled propane cylinder be equipped with an Overfill Prevention
Device (OPD). This code went into effect for most states on April 1, 2002.
An OPD is a safety device designed to prevent the overfilling of a propane
cylinder through a float valve that closes when the propane level reaches
80%. This limits the potential for release of gas when the cylinder is
heated, averting a fire or possible injury. Additionally, the OPD stops
gas flow when the cylinder is not connected.
Facts & Figures from the NFPA Fact Sheet
- As of April 1, 2002, OPDs are required on all propane
cylinders between 4 and 40 pounds propane capacity, per the 1998 edition
of NFPA 58, Liquefied Petroleum Gas Code.
- Cylinders of this size manufactured after September 30,
1998, were required to have an OPD. A typical gas grill cylinder holds
about 20 pounds of propane.
- Propane cylinders with OPDs can be identified by a triangular
hand-wheel (see picture on the right). Some earlier model cylinders
were produced with a round hand-wheel but "OPD" is stamped
on the brass valve body.
- After April 1, 2002, propane cylinders not equipped
with an OPD must be retrofitted with the device before refilling can
occur or properly disposed of and replaced with an OPD-equipped cylinder.
- Many propane dealers will retrofit older cylinders
with an OPD. As there is a charge for this, it may be more economical
to replace the entire cylinder, especially if it is rusty. In many parts
of the U.S., exchange cylinder racks can be used to swap an empty cylinder
without an OPD for a full cylinder equipped with an OPD, for a nominal
fee, eliminating the need to dispose of the cylinder or to have it retrofitted.
- Dispose of propane cylinders safely. Questions about
safe disposal should be answered by local fire departments, hazardous
waste collection sites, or propane refillers. For
questions about propane cylinder disposal in El Dorado County, see information
below or call (530) 621-5300.
- The 2001 edition of NFPA 58 modified requirements
to exempt horizontal cylinders manufactured before October 1, 1998,
from requiring OPDs. Also exempt are cylinders used for industrial trucks,
industrial welding and cutting gases (these cylinders must be labeled
with their use).
DANGERS of Propane
Cylinders
- If your cylinder is damaged or obsolete,
do not abandon it! Abandoned propane cylinders could create
serious environmental and safety problems.
- Do not dispose of your cylinder in
a dumpster or other disposal container! This could create
an explosion hazard.
- Avoid cutting the tank or wheel valve
with a torch. Your cylinder may still contain propane
and create a potential fire and explosion hazard.
- Always keep your propane cylinder
stored upright until you can recycle or exchange it safely.
- Do not use any tank what has any blue
or green discoloration on the valve. This may indicate
that the tank has been used for the storage of ammonia
in illegal drug manufacturing.
Disposal
Sites:
Propane tanks can be legally disposed in
El Dorado County at the following Household Hazardous Waste
disposal sites: Permanent
sites, Temporary sites,
El Dorado Hills site, and
MRF . Sometimes they are accepted at
the Electronic Waste
(E-Waste) events - please check prior to bringing
them to the event.
Cylinder Exchange Locations:
Additional Info:
|